SPRAY APPLY SYSTEM CONCRETE SEALER
Day of the Pour Application
The CS2000 Spray Apply System is a pro-active approach to addressing moisture vapor emissions problem. By applying the CS2000 Spray Apply System the day of the concrete pour, you can be assured that the concrete slab will be able to support the specified floor covering. The CS2000 Spray Apply System is applied the day of the concrete pour just after final finishing and soft cutting in lieu of other curing methods.
The CS2000 Spray Apply System is the most cost effective moisture vapor emission control system in the industry and can be installed for a fraction of the cost, when compared to the typical retrofit systems.
When a floor covering is installed on a below grade, on grade, or above grade concrete slab treated with CS2000 according to manufacturer's instruction, Creteseal shall warrant the floor covering system against failure due to moisture vapor migration or moisture-born contaminates for a period of (15) years from the date of original installation. The Warranty shall cover all labor and materials needed to replace all floor covering that fails due to moisture vapor emission & moisture born contaminates.
The CS2000 Spray Apply System is applied the day of the concrete pour just after final finishing and soff cutting in lieu of other curing methods. The CS2000 Spray Apply System is applied with a low-pressure industrial sprayer at 200 square feet per gallon. After the
concrete sealer is applied it is broomed evenly across the concrete slab until completely absorbed into the concrete surface.